We build garage heaters for the kind of industrial spaces where you don’t want to warm the whole building—just the spot that needs it. Our solution? A high-output halogen lamp that throws intense, focused infrared heat exactly where you point it. This isn’t about cozy comfort. It’s a workhorse, built for drying, curing, or keeping a workshop area at the right operating temperature. Here’s the power setup: we run it on 400V to deliver 2500W through a compact 300mm tube. That voltage choice keeps the current lower, so you can use smaller wiring and cut down on line losses compared to a 230V unit with the same wattage. And because the tube is short, the heat concentrates into a tight footprint. You get serious watt density right where you need it. The tube itself is wrapped in a coated quartz envelope. That special reflective coating pushes the energy forward, so more of the heat goes where you want it and less gets wasted into the housing. The R7s base makes installation a no-brainer. It’s a double-ended connector that handles high temperatures and locks in solid. Just slide the tube into the sockets. No threading. No fiddling. This setup is built for speed. It fires up instantly and delivers direct radiant heat straight to the target—not to the air around it. But that 2500W output means you’ve got to plan your electrical side properly. Make sure the circuit and the thermal setup in your fixture are rated for the load. For engineers, it’s a fast, dependable heat source that specs cleanly—if you size the infrastructure right.